![]()
To deactivate a track, press down on the corresponding control knob. ![]() Initially, the 1, 2, and 3 tracks will appear red, meaning they are active, but we want to deactivate them. If you touch the meter screen once, it will go to a split view, showing the L and R channels at the top, and the 1, 2, and 3 tracks below. The grayed-out Right channel means that the Right channel has been deactivated. Press the Home button again, and the meter should display the Left channel in red, and the Right channel in gray. Go to the second page of menu options and select Record, then Rec L,R and select L. Press the Home button, and then the Menu button. Then choose Custom Setup, where the following settings are recommended: In the System submenu, select Mode, and then select Custom from the three choices (Basic, Advanced, and Custom). If you are using a stereo microphone or pair of microphones, you can skip to the stereo-specific set-up section.įrom the Menu screen, select System. If you are using a single mono microphone, like a shotgun or a mono parabola, follow these instructions for setting up the channels on the MixPre-3. Can be useful to give you confirmation a recording has begun, but a matter of preference. Record Bells: Off or On gives an audible beep through the headphones when you start and stop recording. Rec Trigger: Off not relevant unless you’re connecting with a camera SIMPLE RECORDER SOLO C SCALE SERIES5 seconds is a good option, although you can select more on the II series if you wish. The more you record, the more you will have to work with, though it can add messiness to your files. Pre-roll time: this determines how much buffer is being recorded before you press the record button. If you are using a recorder in the II series, 32 bits is recommended (see below). Sample Rate: 48kHz recommended in most situations) 96kHz can be used if very high frequency sounds are being targeted (this will significantly increase file size.)īit Depth: at least 24 bits is recommended. Channel options will be addressed in the next section, but you can start by setting the following: In the main menu, choose the Record option, where you can set file type and other settings. Finally, in the System sub-menu, change the USB-C option to Power Only. SIMPLE RECORDER SOLO C SCALE BLUETOOTHUsing higher brightnesses will drain batteries more quickly.īack on the System sub-menu, click on the Bluetooth option so it shows Off. A setting between 2-4 works for most conditions, although this is ultimately a personal preference. You can adjust the brightness for both the LCD (main screen) and LED (channel knob) displays. Go into the main menu, click the System sub-menu, go to the second page, and select the Brightness option. Even so, there are several settings that can help save energy.įirst, adjust the brightness of the channel knobs and the screen. The MixPre-3 uses a lot of battery life, so it is highly recommended to use an external lithium battery pack to power it in the field. Once done, tap on the “Set” button on the touch screen. Push the knob in to select the field you want to edit, and then turn the knob to adjust the value. Once in the menu for Date or Time, use the headphone knob on the right side of the recorder to move between the different fields. You can then select either Set Date or Set Time. Tap through to the third page, then choose Date/Time. Touching this button will allow you to move between the three Menu screens (represented by the three dots below the word “Menu”).įrom the main menu, and go to the System sub-menu. Once in the setup menus, a Menu button appears in the top, center section of the touchscreen. The menu and settings are a little more complicated, but they are easy to adjust once you have set up the system for the first time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |